Part Number – 101160615
- 2 cable entries
- Metal enclosure
- 4 Contacts
- 118 mm x 174 mm x 64 mm
Ordering data
| EAN (European Article Number) | 4030661190815 |
| eCl@ss number, Version 9.0 | 27-27-26-01 |
| eCl@ss number, Version 11.0 | 27-27-26-01 |
| ETIM number, version 6.0 | EC000030 |
| ETIM number, version 7.0 | EC000030 |
General data
| Standards | EN 60947-5-1 |
| Active principle | mechanical |
| Slide form | Curvature |
| Enclosure material | Grey cast iron, galvanised |
| Enclosure coating material | painted |
| Gross weight | 1,735 g |
General data – Features
| Number of openers | 2 |
| Number of shutters | 1 |
Mechanical data
| Actuating element | Plunger |
| Mechanical life, minimum | 3,000,000 Operations |
| Contact opening | 2 x 0.5 mm |
| Actuating torque | 0.2 Nm |
Mechanical data – Connection technique
| Terminal Connector | Screw connection |
| Cable section, minimum | 1.5 mm² |
| Cable section, maximum | 2.5 mm² |
| Note (Cable section) | All indications about the cable section are including the conductor ferrules. |
| Wire cross-section | 12 AWG |
Mechanical data – Dimensions
| Length of sensor | 64 mm |
| Width of sensor | 118 mm |
| Height of sensor | 174 mm |
| Diameter of the Plunger | 10 mm |
Ambient conditions
| Degree of protection | IP65 to EN 60529 |
| Ambient temperature, minimum | -30 °C |
| Ambient temperature, maximum | +90 °C |
Ambient conditions – Insulation value
| Rated insulation voltage Ui | 250 V |
| Rated impulse withstand voltage Uimp | 4 kV |
Electrical data
| Thermal test current | 6 A |
| Utilisation category AC-15 | 230 VAC |
| Utilisation category AC-15 | 2.5 A |
| Switching element | NO contact / NC contact |
| Switching principle | Snap switch element |
| Bounce duration, maximum | 43,221 ms |
| Switchover time, maximum | 10 ms |
Notes
| Note (General) | This rotating spindle limit switch with snap-action insert is only fit for use in normal to average operating conditions, e.g. for machine tools, cranes and conveyors. Protection class IP 65 to IEC/EN 60529.By reversing the contacts, the spindle revolutions can be set between 4 and 55 revolutions The run-out towards each side is at least 5 revolutions. |
